Difference between revisions of "Starting CODA for shift workers"

From Hall A Wiki
Jump to: navigation, search
Line 10: Line 10:
 
*Use CODA scripts buttons on first Desktop to start the ROC Xterms and Run Control
 
*Use CODA scripts buttons on first Desktop to start the ROC Xterms and Run Control
  
*If needed use Rstart CODA components
+
*If needed use Restart CODA components
  
 
*In runcontrol make sure sbsts session and config GMN1 are chosen
 
*In runcontrol make sure sbsts session and config GMN1 are chosen
Line 35: Line 35:
 
***start a run
 
***start a run
 
**GEM module not initializing or getting Errors
 
**GEM module not initializing or getting Errors
**open in browser http://hallavme12.jlab.org
+
***Reboot VTP crate : open in browser http://hallavme12.jlab.org
  
 
* All remote switches at  
 
* All remote switches at  
  
 
*if you are stuck check contact expert on slack ( in 4th desktop web browser ) or call DAQ on call ( number on slack channel on-call or on whiteboard)
 
*if you are stuck check contact expert on slack ( in 4th desktop web browser ) or call DAQ on call ( number on slack channel on-call or on whiteboard)

Revision as of 04:38, 12 October 2021

  • DAQ should be running on hadesk4 in a VNC
  • If the VNC is not opened, or after logging in as adaq
 type : RunCoda
 VNC password is adaq password

alternatively connect on vnc on adaq2:4

  • Use CODA scripts buttons on first Desktop to start the ROC Xterms and Run Control
  • If needed use Restart CODA components
  • In runcontrol make sure sbsts session and config GMN1 are chosen
  • To start a run
    • hit configure button in runcontrol, might need to hit it twice if vtpROC20 misses the first configuration
    • hit download button
    • check prescale factors ( To open prescale gui : ssh to sbs-onl@adaq2 and type prescale )
    • hit Start Run button
    • fill in run information in pop up box ( make sure you have correct target / runtype )
  • Pedestal run
    • select GM1_pedestal config
    • start run
    • stop run after at least 30 k events
    • go back to GMN1 configuration and start regular rub
  • Troubleshooting
    • SEB and ER stuck at end of run
      • hit reset in runcontrol
      • hit restart CODA components
      • redo configure and download
      • start a run
    • GEM module not initializing or getting Errors
  • All remote switches at
  • if you are stuck check contact expert on slack ( in 4th desktop web browser ) or call DAQ on call ( number on slack channel on-call or on whiteboard)