Difference between revisions of "Things cryotarget operators should know"
|Line 58:||Line 58:|
* cd Desktop/Screens
* cd Desktop/Screens
Revision as of 16:26, 17 November 2010
Back to DVCS
JP has summarized the main parameters every target operator should be familiar with. If you are not familiar with those parameters you should stop by to another shift before yours come to get acquainted with those with a more experienced target operator. If you have additionnal questions please contact JP Chen firstname.lastname@example.org
Cryotarget for DVCS, due to share cryogenics with Hall C QWeak target, TO must pay attention to the cryogenic situation.
1) Loop 1 for LD2, operating at 22K, ~25 psi
Loop 2 for LH2, operating at 19K, ~25 psi
2) When the target used in beam, set fan to 60 Hz (25%),
and HP heater at beam heat +50 watts (for 10 uA, it is 60+50=110 watts).
When the target not used in beam, set fan to 24 Hz (10%).
and HP heater to 30 watts.
3) Watch loop temperature, pressure, heater power and check fan speed. Watch 15K supply temperature (CTD 673), it should be between 13-14K when Hall C target is cold. Can be 15-16 K when Hall C target is warm. Watch 15K flow (CFI6731A), Hall A should be ~12 g/s when supply is 13-14K (~15 g/s when supply is 15-16K).
4) When target temperature rises (alarm), check the 15K supply temperature and flow. It often is due to 15K supply temperature increasing. In this case, DO NOT increase Hall A flow if Hall C is in full power. Inform the target-on-call. If the target temperature rises significantly (more than 2K), reduce the fan speed to 24 Hz (10%) to protect the fan from burned out.
* If you are confused about anything, turn off the beam, call the expert. * The target operator needs to know how to adjust the JT valve and adjust fan speed.
Rebooting Target IOC
* Go to http://hareboot7 * Username and password are on the paper near whiteboard (see ioc reboot) * Select chan 5 and 6 (iocha13) * Select Control Action "Reboot Immediately". * click Next and then Apply
Restarting Target Alarm Handler
* On the Hall A Cryotarget GUI click on "Alarms" * Double click on "/home/poltar/Screens/ALH". * Double-click on "atarg.alhConfig".
Alarm and Major Events
* Pay attention to alarms. Make sure you know what caused the alarms and take care of them. If you are not sure, turn off beam, call the target expert.
Restarting the GUIs
* Open a terminal on target computer (poltar@poltarac) * cd Desktop/Screens * ./tgtgui * On the NewDesign3.adl screen, click on Cryostat button * On the NewDesign3.adl screen, click on Alarms button