Wednesday, January 31, 2018 3:00pm ET

From Hall A Wiki
Revision as of 16:37, 31 January 2018 by Crowder (Talk | contribs) (Minutes)

Jump to: navigation, search

previous meeting << >> following meeting

Logistic information

 BlueJeans calling instructions:
 Toll-Free Number (U.S.&  Canada):  888-240-2560
 International toll number:         408-740-7256
 Bluejeans CODE:                    734 609 7559
 Bluejeans link:


  1. Status reports


Attendance: Juliette, KK, Cameron, Ernie, Jim, Rakitha

  1. Prototype coil
    1. water test plumbed incorrectly
      1. run in series instead of parallel
    2. shipping on winding device
    3. B-stage - stuck together turn-to-turn when moved to vacuum chamber
      1. rectangle with hole
      2. radius on corners
      3. fiberglass tape half-lapped
      4. B-stage is pre-impregnated tape vs. just tape
      5. w/ latter back-fill with epoxy
      6. former does not make a monolithic structure
      7. ground wrap after w/ fiberglass tape
      8. B-stage can be made with rad-hard epoxy
      9. would still need to make with vacuum impregnation to remove voids
    4. JLAB job, admin by JLAB, technical expertise remains w/ collaboration
    5. testing water flow at MIT-Bates
  2. Other priorities
    1. Radiation dose
      1. using number from spec sheet
      2. not sure if it is just neutrons or E&M
      3. maximum dose limits are very high, but we're running for 30k hours
      4. needs to still look at e- and gamma
      5. more concerned with mechanical integrity than electrical shorts
    2. Sensitivities
    3. segmented coil
  3. Magnet Advisory Group Meeting soon

Return to Teleconferences
Return to MOLLER at 11 GeV E09-005