Gemeel122 log 101 200
From Hall A Wiki
2nd set (Run # 101-200)
| RUN # | Source/Cosmic/Pedestal | Source Position | Time | HV | # of events | notes |
|---|---|---|---|---|---|---|
| 101 | S | Low X, Low Y | 3700 | Bad reading in Y | ||
| 102 | S | High X, High Y | 3700 | No Data recorded - ROC Froze | ||
| 103 | S | "" | "" | No Data recorded - ROC Froze | ||
| 104 | S | "" | "" | Reset ROC | ||
| 105 | S | High X, Low Y | 3700 | Bad reading in Y | ||
| 106 | S | High X, Mid Y | "" | Y Reading Fine | ||
| 107 | S | High X, Low-Mid y | "" | Y Reading Bad | ||
| 108 | P | Changed Y Card - Card was not connected | ||||
| 109 | P | |||||
| 110 | S | High X, Low-Mid Y | Y Reading Bad | |||
| 111 | ABORTED | |||||
| 112 | S | Center | Old readout Card - It is bad. | |||
| 113 | S | Center | ROC FROZE | |||
| 114 | Checked CH1 readout - Nothing | |||||
| 115 | Checked CH0 | |||||
| 116 | S | Mid X, High Y | Y reading Fine | |||
| 117 | P | GEM 3<----- PLOTS | ||||
| 118 | S | Center | 3700 | |||
| 119 | S | Low X, Low Y | "" | Y reading bad | ||
| 120 | S | High X, High Y | "" | Y Reading fine | ||
| 121 | P | Redid Ped Run | ||||
| 122 | S | High X, Low Y | 3700 | Y reading Bad | ||
| 123 | P | Switched Boards on GEM | ||||
| 124 | S | High X, Low Y | 3700 | Y reading Bad | ||
| 125 | Changed Amplifier Output to Slot 2 and messed with DC Voltage | |||||
| 126 | P | |||||
| 127 | S | High X, Low Y | 3700 | Y reading Bad | ||
| 128 | P | GEM 4 <----- PLOTS | ||||
| 129 | C | 3600 | BAD | |||
| 130 | S | Center | 3700 | |||
| 131 | S | Low X, Low Y | 3700 | Y Reading Bad | ||
| 132 | S | High X, Mid Y | 3700 | Y reading good | ||
| 133 | S | High X, Mid-Low Y | "" | Y reading Bad | ||
| 134 | S | "" | 3750 | Y reading Bad | ||
| 135 | S | High X, High Y | 3700 | Y reading good | ||
| 136 | S | High X, High Y | 3700 | Y reading Good, Higher up on Y | ||
| 162 | P | GEM 4. Amplification board 1 | ||||
| 163 | P | GEM 4. Amplification board 2, no difference w/ board 2 | ||||
| 164 | P | GEM 4. Amp board 1. changed T.gem.x1.detmap & T.gem.y1.detmap->slot_lo to 1 in database | ||||
| 165 | S | 3590 | bottom->GEM 4 (source). top->GEM2. 2.73mA | |||
| 166 | S | 3600 | GEM 4 | |||
| 167 | S | GEM4 | ||||
| 168 | P | cram.gem.crl T1 70->60 | ||||
| 169 | P | cramsTprog T1 60->80 | ||||
| 170 | P | T1 80->70
T | ||||
| 171 | P | no input connected. Test to see what problem is | ||||
| 172 | S | Low X, Low Y | 3700 | |||
| 173 | aborted | |||||
| 174 | sS | Low X, Low Y | 3700 | changed to channel 2 | ||
| 175 | P | replaced Y card and conector | ||||
| 176 | P | changed CRAM card | ||||
| 177 | S | Mid X, Mid Y | 3700 | |||
| 178 | P | GEM 2 | ||||
| 179 | C | 3600 | ||||
| 180 | changed T.gem.X1.detmap & T.gem.Y1.detmap ->slot_lo to 1 | |||||
| 181 | S | changed T.gem.X1.detmap & T.gem.Y1.detmap ->slot_lo to 2 (changed back) | ||||
| 182 | S | |||||
| 183 | changed T1 to 50 in CRL code for 551b | |||||
| 184 | P | (kaptons unpluged) | ||||
| 185 | P | |||||
| 186 | S | 3700 | Changed T1 from 50 to 40 in CRL code | |||
| 187 | S | 3700 | CRL code still changed to 40. Data is going to neg(-) input in 550 | |||
| 188 | P | Changed polarity of trigger. Hold -> no difference | ||||
| 189 | S | 3700 | ||||
| 190 | S | 3700 | Changed CRL T1->70 | |||
| 191 | 3700 | Changed CRL T1->60 | ||||
| 192 | ||||||
| 193 | Changed CRL T1-> 50. aborted | |||||
| 194 | gate generator to make trigger hold. T1->50 | |||||
| 195 | S | 3700 | T1 50 -> 30 | |||
| 196 | S | 3700 | T1 30 -> 20 | |||
| 197 | 3750 | T1 20 -> 70 | ||||
| 198 | Clear coming from gate generator | |||||
| 199 | P | |||||
| 200 | S | 3750 |
