HV Control GUI

This GUI is used to enable/set particular voltage channels remotely.

1. Start jmenu on the compton
2. Type hv in the search bar
3. Select HV Card 3 - the first channel in this card is the photon detector. Nominal voltage 1750 V.
4. For the scintillators on the laser table, select HV Card 1, channels 9, 10 , 11, 12. Nominal HV is +1800 V.

The information below is for historical reference.

These Photon Detector channels are for PREX/CREX running conditions:

	Slot	Cha	HV
Side (V) Finger	SL-6	CH-10	-950 V
Top (H) Finger	SL-6	CH-11	-1000 V
GSO (PhDetector)	SL-12	CH-11	See note 1

Note 1: For PRex the GSO is in an independent HV supply, set to -2340 V.

In addition, there are four scintillators in the laser table, two upstream and two downstream of the interaction point. Note: The following voltages are all positive.

	Slot	Channel	HV
DS Top	SL-9	CH-0	+1800 V
DS Bottom	SL-9	CH-1	+1800 V
US BR	SL-9	CH-2	+1800 V
US BL	SL-9	CH-3	+1800 V

Return to Compton

OLD INSTRUCTIONS

1. Log on to adev@adaq1 or adev@adaq2.
2. cd slowc
3. ./hvs BEAMLINE

Old channel for PbWO4: Slot 12, Channel 11, set to about -1690V. (desired voltage as of 2016-11-10 to 2016-12-31)

Return to Compton