View source for HV Control GUI

This GUI is used to enable/set particular voltage channels remotely.


# Log on to ''aslow@adaqsc''
# ''cd slowc''
# ''./hvs BEAMLINE''


This will start the GUI. Available channels should say "S1, S5, S6, S9, S12". Navigate to the table and select a channel. ''Make sure you know the desired voltage before proceeding.'' Check the box to enable, then click the HV On/Off on the left, if it is not already active.

These Photon Detector channels are for PREX/CREX running conditions:
{| class="wikitable"
!
! Slot
! Channel
! HV
|-
| GSO (PhDetector)
| SL-12
| CH-11
| -1700 V
|-
| Side Finger
| SL-6
| CH-10
| -xxxx V
|- 
| Top Finger
| SL-6
| CH-11
| -xxxx V
|}

Return to [[Compton]]

'''OLD INSTRUCTIONS'''

# Log on to ''adev@adaq1'' or ''adev@adaq2''.
# cd slowc
# ./hvs BEAMLINE

Old channel for PbWO4: Slot 12, Channel 11, set to about -1690V. (desired voltage as of 2016-11-10 to 2016-12-31)

Return to [[Compton]]