View source for Thursday, May 21, 2015 2:00pm EST

Last meeting: [[Tuesday, April 14, 2015 11:30am EST]]


== Agenda ==
<br><br>
* Status reports
** Juliette
** Jason/Ernie
* Collimator discussion
** [http://ace.phys.virginia.edu/MollerSpectrometer/346 elog-346] - Rakitha
* Next meeting

<br><br>

== Minutes ==

Attending: Jim, Jason, KK, Tyler, Rakitha, Juliette, Ernie, Tyler

* Status reports
** Juliette
*** Student working on sensitivity study for upstream coils
** Jason/Ernie - Emerson-Tesla visit
*** Tooling and single prototype
*** Prepared to give budgetary number
*** Need better radiation numbers on energy deposited in coils/ at edge of feasibility
*** KK says that source of power is going to be eliminated or reduced
*** Epoxy 425 - if it can meet the requirements (other with bad viscosity has 2 orders of magnitude better radiation hardness)
*** Bigger conductor worse for keystoning; smaller conductor easier to make?
*** DDG not applicable for high radiation
*** not needed for quote but bending radii might need to change; need to evaluate physics
** 2016 MOLLER work cost estimate (prototype?) in a week (use estimate from Robin review) 
*** prototype
*** collimator design higher priority 
** Director's review late September/early October (if not late August)
*** Magnet Advisory group meeting mid-late July (before July 15th or after August 15th)
*** Week after July 4 
*** invite internal advisory group to a regular meeting 
**** Juliette will contact advisory group members for availability
* Collimator discussion - [http://ace.phys.virginia.edu/MollerSpectrometer/346 elog-346] - Rakitha
* next meeting June 11
* Next meeting


<br><br> Return to [[Teleconferences]]
<br> Return to [[MOLLER at 11 GeV E09-005]]