Difference between revisions of "Console Servers"
(New page: In the counting room we have a "Console Server" which allows network access to serial ports like for the vxWorks-based VME cpus. At present, this is set up for the Parity DAQ in the count...) |
|||
| Line 18: | Line 18: | ||
To get to another port, replace "4" by the port number in the above commands. I suppose "ssh" is preferred. The ACC division does not allow telnet. | To get to another port, replace "4" by the port number in the above commands. I suppose "ssh" is preferred. The ACC division does not allow telnet. | ||
| − | To use the device with a 5100 or 6100 board, you use a standard CAT6 network cable with RJ-45 connectors; however, you also need an adaptor cable on the side of the VME computer because the pinout is scrambled. If the 8 pins on the console are labelled [a b c d e f g h] then the VME side needs to be [g a h f c d e b] | + | To use the device with a 5100 or 6100 board, you use a standard CAT6 network cable with RJ-45 connectors; however, you also need an adaptor cable on the side of the VME computer because the pinout is scrambled. If the 8 pins on the console are labelled [a b c d e f g h] then the VME side needs to be [g a h f c d e b]. I have a few of these cables thanks to Brad Cumbia. |
To setup and administer the "acons1" console server, one can login (it's a linux PC) and use command lines, OR you can use a web interface: | To setup and administer the "acons1" console server, one can login (it's a linux PC) and use command lines, OR you can use a web interface: | ||
Revision as of 12:56, 2 November 2015
In the counting room we have a "Console Server" which allows network access to serial ports like for the vxWorks-based VME cpus. At present, this is set up for the Parity DAQ in the counting room, but it could be used elsewhere -- basically anywhere that a "portserver" is used.
For now, I've put the reference manuals here: adaq1:~adaq/doc/acs
To connect to port 4 on our console server "acons1", use a command like this
telnet acons1 7004
or
ssh adaq:ttyS4\@acons1
Use the same password for "adaq" as you do on the other hall A computers.
To exit from the console server, type "ctrl-Z" and then type "exit".
To get to another port, replace "4" by the port number in the above commands. I suppose "ssh" is preferred. The ACC division does not allow telnet.
To use the device with a 5100 or 6100 board, you use a standard CAT6 network cable with RJ-45 connectors; however, you also need an adaptor cable on the side of the VME computer because the pinout is scrambled. If the 8 pins on the console are labelled [a b c d e f g h] then the VME side needs to be [g a h f c d e b]. I have a few of these cables thanks to Brad Cumbia.
To setup and administer the "acons1" console server, one can login (it's a linux PC) and use command lines, OR you can use a web interface: https://acons1/
The first time you login as "root" the password is a factory default, but that passwd needs to be changed. You can add a user account, and as I said above, I have added the "adaq" account.
