Difference between revisions of "HV Control GUI"
From Hall A Wiki
(Added content to new page) |
m |
||
| Line 1: | Line 1: | ||
This GUI is used to enable/set particular voltage channels remotely. | This GUI is used to enable/set particular voltage channels remotely. | ||
| − | # Log on to 'adev@adaql1' or 'adev@adaql2'. | + | # Log on to ''adev@adaql1'' or ''adev@adaql2''. |
| − | # 'cd slowc' | + | # ''cd slowc'' |
| − | # './hvs BEAMLINE' | + | # ''./hvs BEAMLINE'' |
This will start the GUI. Navigate to the table and select a channel. ''Make sure you know the desired voltage before proceeding.'' Check the box to enable, then click the HV On/Off on the left, if it is not already active. | This will start the GUI. Navigate to the table and select a channel. ''Make sure you know the desired voltage before proceeding.'' Check the box to enable, then click the HV On/Off on the left, if it is not already active. | ||
Revision as of 10:49, 12 February 2016
This GUI is used to enable/set particular voltage channels remotely.
- Log on to adev@adaql1 or adev@adaql2.
- cd slowc
- ./hvs BEAMLINE
This will start the GUI. Navigate to the table and select a channel. Make sure you know the desired voltage before proceeding. Check the box to enable, then click the HV On/Off on the left, if it is not already active.
