Difference between revisions of "HV Control GUI"
From Hall A Wiki
m |
m (Add link back to main Compton page) |
||
| Line 1: | Line 1: | ||
This GUI is used to enable/set particular voltage channels remotely. | This GUI is used to enable/set particular voltage channels remotely. | ||
| + | |||
# Log on to ''adev@adaql1'' or ''adev@adaql2''. | # Log on to ''adev@adaql1'' or ''adev@adaql2''. | ||
# ''cd slowc'' | # ''cd slowc'' | ||
# ''./hvs BEAMLINE'' | # ''./hvs BEAMLINE'' | ||
| + | |||
This will start the GUI. Navigate to the table and select a channel. ''Make sure you know the desired voltage before proceeding.'' Check the box to enable, then click the HV On/Off on the left, if it is not already active. | This will start the GUI. Navigate to the table and select a channel. ''Make sure you know the desired voltage before proceeding.'' Check the box to enable, then click the HV On/Off on the left, if it is not already active. | ||
| + | |||
| + | |||
| + | Return to [[Compton#Spring_2016_Compton]] | ||
Revision as of 10:52, 12 February 2016
This GUI is used to enable/set particular voltage channels remotely.
- Log on to adev@adaql1 or adev@adaql2.
- cd slowc
- ./hvs BEAMLINE
This will start the GUI. Navigate to the table and select a channel. Make sure you know the desired voltage before proceeding. Check the box to enable, then click the HV On/Off on the left, if it is not already active.
Return to Compton#Spring_2016_Compton
