Difference between revisions of "Thursday, Mar. 03: DAY Shift"
From Hall A Wiki
| Line 11: | Line 11: | ||
- Experts will perform this (Dave/Thir/...) | - Experts will perform this (Dave/Thir/...) | ||
- Calo. HV off<br> | - Calo. HV off<br> | ||
| + | Instruction: <br> | ||
| + | [http://hallaweb.jlab.org/equipment/BCM/HallA_BCM_linearity.pdf DOC1][http://hallaweb.jlab.org/equipment/BCM/HallA_Unser_0L02_cal.pdf DOC2] | ||
| + | <br> | ||
3/ Set up beam through Compton chicane<br> | 3/ Set up beam through Compton chicane<br> | ||
4/ Production Data with stable beam current<br> | 4/ Production Data with stable beam current<br> | ||
| Line 16: | Line 19: | ||
* Detailed instructions [https://hallaweb.jlab.org/ here] | * Detailed instructions [https://hallaweb.jlab.org/ here] | ||
| + | |||
| + | |||
| + | |||
| + | |||
| + | <b>Upcoming event(Long Term)</b> | ||
| + | * Beam study (Thursday, 3/10) | ||
| + | * Target boiling test | ||
| + | |||
Revision as of 09:56, 3 March 2016
Go back to Daily Run Plan Daily Run Plans
- General considerations
Specific mission
- Note: MCC RF recovery (8:30-11:30AM) Down time
1/ Doug: Series of magnet measurement <: 1hr / no beam/ but beam permit
- No controlled access !
Once RF recovery is done,
2/ BCM calibration (high beam current 30uA(60 ideal) with FC & empty target
- Experts will perform this (Dave/Thir/...)
- Calo. HV off
Instruction:
DOC1DOC2
3/ Set up beam through Compton chicane
4/ Production Data with stable beam current
- Detailed instructions here
Upcoming event(Long Term)
- Beam study (Thursday, 3/10)
- Target boiling test
BPM/Spot++ Check
- After beam lost for considerable time (like beam study, pass change,...)
- Ask MCC to run 5uA wth carbon hole target and make sure you can see the hole through Spot++
