Difference between revisions of "Special Procedure For Moving Target"
From Hall A Wiki
(→Move target during production (automatic spin flip)) |
(→Move target during production (automatic spin flip)) |
||
| Line 7: | Line 7: | ||
* '''NEVER''' move target during a sweep | * '''NEVER''' move target during a sweep | ||
| + | |||
* Move target from production ( He3 ) to other locations | * Move target from production ( He3 ) to other locations | ||
# If there is no production run, skip to step 4 | # If there is no production run, skip to step 4 | ||
| Line 12: | Line 13: | ||
# Do '''Flip NOW''' | # Do '''Flip NOW''' | ||
# Turn '''OFF'''(pause) ''Auto Flip'' | # Turn '''OFF'''(pause) ''Auto Flip'' | ||
| − | # Move | + | # Move target to new position |
| + | |||
| + | * Move target to production ( He3 ) from other locations | ||
| + | # Move target to He3 position for production | ||
| + | # Turn '''ON'''(pause) ''Auto Flip'' | ||
| + | # Do '''Flip NOW''' | ||
| + | # Once flip is done, start data taking | ||
Revision as of 22:57, 8 November 2008
Move target while spin-up curve test
- NEVER move target during a sweep
- Time for next sweep can be estimated by adding wait time to last sweep time
Move target during production (automatic spin flip)
- NEVER move target during a sweep
- Move target from production ( He3 ) to other locations
- If there is no production run, skip to step 4
- Stop current data taking
- Do Flip NOW
- Turn OFF(pause) Auto Flip
- Move target to new position
- Move target to production ( He3 ) from other locations
- Move target to He3 position for production
- Turn ON(pause) Auto Flip
- Do Flip NOW
- Once flip is done, start data taking
