Difference between revisions of "Special Procedure For Moving Target"
From Hall A Wiki
(→Move target during production (automatic spin flip)) |
(→Move target during production (automatic spin flip)) |
||
| Line 9: | Line 9: | ||
* Move target from production ( He3 ) to other locations | * Move target from production ( He3 ) to other locations | ||
| − | # If there is no production run, skip to step 4 | + | # If there is no production run since last flip, skip to step 4 |
# Stop current data taking | # Stop current data taking | ||
# Do '''Flip NOW''' | # Do '''Flip NOW''' | ||
Revision as of 23:04, 8 November 2008
Move target while spin-up curve test
- NEVER move target during a sweep
- Time for next sweep can be estimated by adding wait time to last sweep time
Move target during production (automatic spin flip)
- NEVER move target during a flip
- Move target from production ( He3 ) to other locations
- If there is no production run since last flip, skip to step 4
- Stop current data taking
- Do Flip NOW
- Turn OFF(pause) Auto Flip
- Move target to new position
- Move target to production ( He3 ) from other locations
- Move target to He3 position for production
- Turn ON(pause) Auto Flip
- Do Flip NOW
- Once flip is done, start to take data
