Revision as of 10:59, 11 March 2009

Plan/Checklist for Re-Installing the BigBite Hadron DAQ (including Neutron Detector).

Hadron Package DAQ

• Remove all NIM/CAMAC/VME modules that will not be used.
• Replace Linear Fi/Fo in second NIM bin.
• Verify functionality and low noise of x10 Amps, 50/50 Splitters, and Linear Fi/Fo.
  • Recable all dE linear sums (L+R) from 50/50 splitters and to CAMAC Discriminators
• Recable all E (dE) from x10 Amplifiers (50/50 splitters) to CAMAC Discriminators
• Verify mapping of E and dE delay line from x10 Amplifiers to VME ADCs.
• Cable E and dE scintillators from Hadron Package to DAQ Weldment Patch Panels
• Move all target spin electronics to another location?

Neutron Detector DAQ

• Acquire 2 NIM bins (300W) from Electron Package Frontend
• Acquire 16 x10 Amplifiers (NIM Bin modules)
• Acquire 2-4 wire-tie panels.
• Acquire 16 CAMAC Discriminators
• Acquire all patch cables
  • 240 for Patch Panel to x10 Amp
  • 240 for x10 Amp to discriminators
  • 240 for x10 Amp to Delay Patch Panel
  • 240 for Delay Patch Panel to FASTBUS TDCs (may already be there from Electron Package)
  • 16 flat ribbon for discriminators to FASTBUS TDCs (may already be there from Electron Package)
• Install NIM bins and wire-tie patch panel in same rack as CAMAC crate.
  • Install 8 x10 Amps per NIM Bin
• Verify functionality and low noise of x10 Amps.
• Cable up and map all patch cables
• Acquire TS-TIR handshake cable (RightHRS to BigBite Weldment)
• Acquire 2 RG-8 for L1A (RightHRS to BigBite Weldment)
• Acquire 4 RG-58 for redundant scaling of RightHRS triggers (RightHRS to BigBite Weldment)