HV Control GUI
From Hall A Wiki
Revision as of 10:52, 12 February 2016 by Lthorne (Talk | contribs) (Add link back to main Compton page)
This GUI is used to enable/set particular voltage channels remotely.
- Log on to adev@adaql1 or adev@adaql2.
- cd slowc
- ./hvs BEAMLINE
This will start the GUI. Navigate to the table and select a channel. Make sure you know the desired voltage before proceeding. Check the box to enable, then click the HV On/Off on the left, if it is not already active.
Return to Compton#Spring_2016_Compton
