HV Control GUI
From Hall A Wiki
Revision as of 11:18, 10 November 2016 by Lthorne (Talk | contribs) (Updated description of HV GUI table and desired voltage. -LT)
This GUI is used to enable/set particular voltage channels remotely.
- Log on to adev@adaql1 or adev@adaql2.
- cd slowc
- ./hvs BEAMLINE
This will start the GUI. Available channels should say "S1, S5, S6, S9, S12". Navigate to the table and select a channel. Make sure you know the desired voltage before proceeding. Check the box to enable, then click the HV On/Off on the left, if it is not already active.
Currently, we are working only with Slot 12, Channel 11, set to about -1690V. (desired voltage as of 2016-11-10)
Return to Compton
