Special Procedure For Moving Target
From Hall A Wiki
Revision as of 13:33, 18 November 2008 by Yqiang (Talk | contribs) (→Move target during production (automatic spin flip))
Move target while spin-up curve test
- NEVER move target during a sweep
- Time for next sweep can be estimated by adding wait time to last sweep time
Move target during production (automatic spin flip)
- NEVER move target during a flip
- Move target from production ( He3 ) to other locations
- If there is no production run since last flip, skip to step 4
- Stop current data taking
- Do Flip NOW
- Turn OFF(pause) Auto Flip
- Ask MCC to mask beam
- then move target to new position
- Move target to production ( He3 ) from other locations
- Ask MCC to mask beam
- Move target to He3 position for production
- Turn ON(pause) Auto Flip
- Do Flip NOW
- Once flip is done, start to take data