HV Control GUI

This GUI is used to enable/set particular voltage channels remotely.

1. Log on to aslow@adaqsc
2. cd slowc
3. ./hvs BEAMLINE

This will start the GUI. Available channels should say "S1, S5, S6, S9, S12". Navigate to the table and select a channel. Make sure you know the desired voltage before proceeding. Check the box to enable, then click the HV On/Off on the left, if it is not already active.

These Photon Detector channels are for PREX/CREX running conditions:

	Slot	Cha	HV
Side (V) Finger	SL-6	CH-10	-950 V
Top (H) Finger	SL-6	CH-11	-1000 V
GSO (PhDetector)	SL-12	CH-11	See note 1

Note 1: For PRex the GSO is in an independent HV supply, set to -2340 V.

In addition, there are four scintillators in the laser table, two upstream and two downstream of the interaction point. Note: The following voltages are all positive.

	Slot	Channel	HV
DS Top	SL-9	CH-0	+1800 V
DS Bottom	SL-9	CH-1	+1800 V
US BR	SL-9	CH-2	+1800 V
US BL	SL-9	CH-3	+1800 V

Return to Compton

OLD INSTRUCTIONS

1. Log on to adev@adaq1 or adev@adaq2.
2. cd slowc
3. ./hvs BEAMLINE

Old channel for PbWO4: Slot 12, Channel 11, set to about -1690V. (desired voltage as of 2016-11-10 to 2016-12-31)

Return to Compton