Difference between revisions of "G2p shifts"
From Hall A Wiki
(→How To Avoid Disasters) |
|||
| Line 22: | Line 22: | ||
* Target [https://hallaweb.jlab.org/wiki/index.php/Target_Troubleshooting_Procedures Troubleshooting] and [https://hallaweb.jlab.org/wiki/index.php/Solid_Polarized_Target target overview] | * Target [https://hallaweb.jlab.org/wiki/index.php/Target_Troubleshooting_Procedures Troubleshooting] and [https://hallaweb.jlab.org/wiki/index.php/Solid_Polarized_Target target overview] | ||
| − | == | + | ==Shift Instructions == |
* The septa current must be set to match each new spectrometer dipole momentum setting. | * The septa current must be set to match each new spectrometer dipole momentum setting. | ||
* Make sure to acknowledge the DAQ popup messages for Start and End of every run. | * Make sure to acknowledge the DAQ popup messages for Start and End of every run. | ||
Revision as of 15:20, 13 April 2012
This page is updated frequently. Please hit Reload at least once per shift.
Contents
Basic Resources for Shift Workers
- Links: (Halog) (tlog)(g2pwiki) (ShiftSchedule) (MCC) (bta) (LSummary) (RSummary)
- Today's runplan
- Expert contact list and Expert Shifts
- Run Sheets (pdf) and Shift checklist
How Tos
- How to run the g2p DAQ
- How to Set the Spectrometer and Septa Magnets
- How to Cycle the Quadrupoles
- How to make vertical correction to target insert
- How to take HARP scan
- How to recover the beam after an extended (>4 hour) down: G2p-beam-recovery
- How to recover BPM positions after a long beam trip or tune change
- How to check Bleed-thru
- How to Set the Slow Raster
- How to check IHWP change in state and alarm
- How to control the Hall A Dump Camera Light
- How to run the Online Replay
- Target Troubleshooting and target overview
Shift Instructions
- The septa current must be set to match each new spectrometer dipole momentum setting.
- Make sure to acknowledge the DAQ popup messages for Start and End of every run.
- Keep a stripchart running of the septa currents. Log any fluctuations, and notify Run Coordinator.
- Take bleedthru measurement once a shift
- Make sure you know exactly what you are doing if operating the Sieve Slit. Compare to this photo
Useful Links
- The g2p Analysis Guide
- Beamline Component locations
- Chicane Positions
- MCC Whiteboard +offsite access to logs (courtesy Brad)
- d2n HowTo (Please note some info is out of date).
- Spring11 HowTo (Please note some info is out of date).
- Online Replay Guide (detailed) (Old Transversity Guide) (Please note some info is out of date).
- mysql Run Database for gep/g2p
- Hall A Moller
Notes
- The Coda configuration is: LHRS, RHRS
- Hall A current : Open Monticello / Wall / Hall A GUI, and look at the 1H00 BCM.
- For Hall A tools screen, on hacuser type "NewTools" which pops up EOSMenu. Select "HLAmain".
- For Stripchart, click toolbox on bottom of desktop menu
- IHWP1 flips the beam helicity. IHWP2 is passive (actually a full wave plate) and will not flip the helicity. The epics var for IHWP2 is IGL1I00DIOFLRD :13056 means the passive wave-plate is in. 8960 is out..
